Class-8 Heavy Truck Duty Cycle Project Final Report - Center for ...

i) Click OK.
ii) Click FCS Setup > Format FCS RAM Disk.
iii) A TCE Message as follows should appear:
“Formatting the FCS RAM disk will destroy all test data, test
setup, and system files! Are you sure you want to proceed?”
iv) If all necessary data has been saved already (or if the
unit is new and has not been used for any data storage yet),
click Yes.
v) After several minutes, a TCE Message will be displayed
similar to the following:
“The eDAQ has been reset. Please wait for the eDAQ to
complete the boot cycle and then you can continue TCE
interface operations.”
vi) Click OK and wait for the eDAQ to complete its boot
cycle. When the yellow light has turned off (the red and
green lights may be continuously lit), close all open windows
in the TCE software. (It is not necessary to close and
reopen TCE.)
vii) Click File > New Setup as before. A message will
appear regarding the reset memory of the eDAQ. Click OK,
and the red light should turn off, leaving only the green light
on.
viii)Select the Hardware Setup window and click on Query. A
list of the hardware associated with the eDAQ will be
generated in this window.
Figure 7.2.2-1: Hardware Setup Window
4) The following list of hardware will appear. Select each as
indicated below and click Config.
a) Main Processor (MPB) – no configuration necessary
b) MPB Serial Bus (MPBSer) – Select the VaisalaWXT database
and click OK
D-33