siemens - Public Service Commission

Crystal River Unit 3
Nuclear Power Station
Replacement Turbine Generator
Table of Conformance - Technical
Comments
Furnish and deliver all spare parts required during construction.
Shipment to the job site shall be the responsibility of the Seller.
SCOPE OF SUPPLY BY OTHERS
Access to Systems Design Information: Identification of the required information is
the Sellets responsibility.
Purchaser shall receive or duplicate necessary documents such as drawings,
procedures, specifications, etc.
Modifications to existing mechanical systems, components, including piping and
hangers as required for the new installation.
Modifications to existing turbine control systems, instrumentation and electrical
systems as required for compatibility with replacement equipment. Owner shall
describe any such modifications as described in Section 1.7.5.
Modifications to existing generator interface systems and equipment such as
generator cooling water supplies, generator busses, generator breakers, main
transformers and protective relaying as required for compatibility with replacement
equipment.
Any existing parts that require replacement as a result of disassembly of the
existing components for final installation will be supplied by the Owner.
Disposal of removed components that shall not be reused.
Operation personnel to perform shutdown, startup, draining, filling, isolation. and
other normal system operating functions.
Safety clearance and tagging of all equipment.
Removal, inspection, and installation of instrumentation.
Electric power, lighting, water, compressed air, and overhead crane facilities.
Removal and installation of insulation.
All electrical disconnects and terminations required to perform work.
Construction and removal of scaffolding.
Radiation protection technicians if required.
Unescorted access training for Contractor's personnel.
Preparation of post installation test procedures.
Supply of test instrumentation.
Performance of post installation tests and preparation of associated test reports.
SCOPE OF SERVICES
Design, fabrication, shipping, inspection and factory testing of equipment, including
implementation of Quality Control procedures to ensure completed equipment
satisfied the specification and design requirements.
Factory assembly of stationary components to validate dimensional and
configuration interface with retained systems, structures and components.
Doc #E0846
4/10/2008 P = Paragraph No PEF-NCR-0 1296 12