siemens - Public Service Commission

Progress Energy Crystal River Unit 3
Request for Proposal for Engineering Services to Upgrade Secondary System
6/25/2007
PM-0020, Vendor Quality Program for Critical Non-Safety Equipment. The
tasks where this requirement applies are indentified in the individual task
descriptions.
2.0 DEFINITIONS
The following definitions shall apply to this Specification:
Owner - Progress Energy
Purchaser - Owner Representative
Buyer - Owner Representative
Seller - Firm proposing lo supply the subject equipment
Supplier - Firm awarded the order for the subject equipment
Contract - Equipment and Service Supply Contract
3.0 REFERENCES
3.1 Codes and Standards
The following codes and standards should be used in developing design and
equipmenl specifications. Note that only recognized US. standards and
equivalent International standards will be accepted. A list of applicable
International codes and standards shall be submitted, in English, for
Engineets acceptance prior to use. The design, fabrication, materials,
workmanship, and testing of all equipment shall be in accordance with the
buyer's standards and applicable codes. In the event of an apparent conflict
among standards, codes and this specification, the seller shall identify such
conflict. The Seller shall obtain written resolution of such conflict from the
purchaser prior to proceeding with work involwng the conflict. When
standards are referenced in this specification without current or effective
dates, the latest revision of the standard specification in effect as of the date
of the Contract shall be considered applicable. Any modifications to the
standard specifications included herein shall be with the express written
approval of the purchaser.
3.1.1 Heat Exchange Institute (HEI)
a. Standards for Power Plant Heat Exchangers
b. Standards for Steam Surface Condensers
3.1.2 Electrical equipment shall be designed, constructed and tested in
accordance with the following standards:
a. Institute of Electrical and Electronics Engineers (IEEE):
i. Standard General Principles for Temperature Limits in the
Rating of Electrical Equipment and for Evaluation of
ii.
iii.
iv.
Electrical Insulation, IEEE 1 I
Neutral Grounding Devices, IEEE 32.
Recommended Practice for Testing Insulation Resistance of
Rotating Machinery, IEEE 43
Test Procedures for Polyphase Induction Motors and
Generators, IEEE 112A.
b. American National Standards Institute (ANSI):
i. National Electric Safety Code, ANSI C2.
ii. Switchgear, ANSI C37.
18
PEE'-NCR-0 1984