02.06.2014 Views

siemens - Public Service Commission

siemens - Public Service Commission

siemens - Public Service Commission

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Alstom Proposal # SD22007, CR3 EPU Turbine Generator Retrofit MeetinP Notes, 05/15/07: Pg. 2 of 7<br />

General Notes:<br />

0 HP Turbine and Generator must be opened in 2007 for field measurements. Is open and close cost included?<br />

- Re: Requested Alstom to consider this R&D-cost to them.<br />

0 Evaluate performance of larger 16.8M2 (57”LSB) LP Turbine.<br />

.Re: - Alstom presented performance curve for 47” and 57” LSB. 57” performs be<br />

Average benefit of 57” LSB is approximately 3MW/year. Cost is<br />

Canyon and performance was much better than expected.<br />

CONFIDENTIP.!.<br />

In. Hg. Both perform the same above 2.7 In. Hg.<br />

Note: the 57”LSB was installed at Diablo<br />

0 Heat balance indicates low feed water temperature between 2009 and 2011 (pg. 201,207,208). What is plant impact?<br />

- Re: Ted say’s reactor is not affected. Lower feedwater temperature is in Alstom heat balance and would not be corrected for in a plant performance<br />

test. Areva would have to evaluate / model the Alstom heat balance for EPU.<br />

0 PE must verify generator frame 75 psi H2 pressure rating for generator stator rewind.<br />

- Re: This is responsibility of PE. Will need Siemens support to document.<br />

0 Support systems for water cooled stator skid and static excitation system are additional cost.<br />

- Re: Alstom requested to provide requirements. See engineering issues.<br />

Evaluate control room impact for new systems.<br />

- Re: Alstom requested to provide requirements. Pump controls and annunciator inputs.<br />

Scope of Supply Comments:<br />

HP Turbine: 7 stage, full impulse design<br />

0 New nozzle plates are fitted into existing nozzle box. Existing nozzle plates may need destructive removal. Is machining or repairs to the<br />

existing nozzle box included?<br />

- Re: Contingency repairs will be extra scope.<br />

0 New inner and outer glands are provided. New gland seals machined for rotor clearance. Are both inner and outer glands type 405 ss (pg.<br />

19)?<br />

- Re: Alstom stated the HP turbine outer glands are poJ included. Proposal was in error. Inner glands are stainless steel.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!