siemens - Public Service Commission

ATTACHMENT 3
Sheet 4 of 5
RNP Personal Protective Equipment Site Hazard Assessment
29 CFR 1910 Subpart I
Areas Exempt from General Hard Hat Requirements (when overhead lifting or any other head
injury hazards exist, head protection must be worn):
Offices
Shop Areas and Yards Areas (except
when required by task)
O&M and Auxiliary Building Tool Rooms
From Dress-out area to CV entrance
(during refueling outages)
Instrument Calibration Facility
Bath and Shower Rooms
Crane, forklift or other vehicles with
overhead protection
Safeguards Room
4160 Switchgear Room
NB Battery Room
Spent Fuel Pool Area
Tool Decon Area in the Radwaste
Building
Hagan Room
a
a
a
0
a
a
0
0
a
0
a
a
0
Control Rooms
Designated Warehouse Areas (except
when required by task)
Laboratories
HP Work Area (except when required by
task)
Respirator Decon Facility
Cable Spread Room
Spent Fuel Building Roof (when roof is
open)
EllE2 Room
Control Rod Drive Room
C Battery Room
Sorting Area in the Radwaste Building
WWDS Room
Locker Rooms
1910.95 HEARING PROTECTION
Wear approved hearing protection in areas 185 dBA. These areas will be designated or posted:
"Caution Hearing Protection Required"
The entire Turbine Building is designated a "Hearing Protection Required" area during operation.
Due to varying plant conditions, there may be times when hearing protection will be required in
areas not posted as "Hearing Protection Required".
Due to very high noise levels, some plant areas will require two (2) sets of hearing protection. This
will consist of one set of earplugs AND earmuffs. These areas will be designated by signs stating:
"Caution - Double Hearing Protection Required"