RealFlight G3 Manual - Great Planes Software Support

MINIMUM BAR HEIGHT-
This setting determines the lowest height that the bar will reach during the Event.
To adjust the Minimum Bar Height, click on the corresponding value. Enter the
desired value directly from the keyboard or via the mouse wheel.
MAXIMUM BAR HEIGHT-
This setting determines the highest setting (starting value) that the bar will reach
during the Event.
To adjust the Maximum Bar Height, click on the corresponding value. Enter the
desired value directly from the keyboard or via the mouse wheel.
DISTANCE TO DROP BAR EACH ROUND-
After a participant successfully passes under the limbo bar, on their next attempt the
bar will lower by the amount indicated in this setting.
To adjust the distance to lower the bar each round, click on the corresponding value.
Enter the desired value directly from the keyboard or via the mouse wheel.
COMMIT LINE DISTANCE-
This indicates the distance between the commitment lines and the limbo bar. There
is a commitment line on either side of the Limbo bar and participants may approach
from either side. These lines detect an attempted pass at the limbo bar.
To adjust the distance, click on the corresponding value. Enter the desired value
directly from the keyboard or via the mouse wheel.
DISTANCE BETWEEN POLES-
The Value entered here indicates the distance between the two vertical poles that
support the limbo bar. The wider the space between the poles, the easier it is to pass
through the gate, so to speak.
R/C Simulator RealFlight Chapter 9. The Events Menu • 267