RealFlight G3 Manual - Great Planes Software Support

To select on of these sessions, click on the respective session and then click OK.
Alternatively, you may double-click on the Session Name to join.
Note: if you are using an updated version of Windows XP (Service Pack 2 or later),
you may have Windows Firewall installed and running. If this is the case, Windows
Firewall will pop up a warning dialog (similar to that shown below) the first time
you use the Search function. You must select the Unblock option in order to allow
RealFlight G3 to continue searching.
SESSION NAME-
The Session Name column displays the name of all available sessions. If you have
not searched (and found) a session, or entered an IP address, the Session Name will
remain blank.
HOST-
This column shows the IP address of the Host computer. If you have accessed the
address via the Search function, this information automatically fills in for you when
you select the session. If you participate in a Multiplayer session via a LAN, you do
not need to fill in the IP address. If you participate in a private session, fill in the IP
address here. When completed, click OK to proceed.
PORT-
This information is important if you are attempting to participate in a Multiplayer
session and the computer is located behind a firewall or NAT. The Port Number will
route your computer’s data through the firewall. It is imperative that this port
number matches the port number of the Host.
PLAYERS-
This column shows the users how many Players are participating in a given
Multiplayer session. The Host determines the number of allowable participants.
R/C Simulator RealFlight Chapter 10. The Multiplayer Menu • 291