Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

More documents

Recommendations

Info

CONNECTING BY ISDN1. Connect the ISDN cable (use the provided Ethernet cable – it is a dual-use cable for bothEthernet and ISDN) to your computer’s or phone’s ISDN port, and insert the other end of theconnector into the Terminal’s ISDN port.2. At the Terminal, slide the cable through the rubber door slot in order to secure and protectthe connection.CONNECTING BY WLANIf you have not previously used the terminal’s WLAN interface, it has to be enabled fromLaunchPad, with your computer connected to the terminal using either the USB or Ethernetinterface. You can also enable the Wireless Encryption Protocol for added security. When theterminal’s WLAN interface is enabled, the WLAN LED is either green (WEP is enabled) or red (WEPis not enabled).Then any computer with a WLAN interface can detect the terminal’s WLAN SSID, and connectto it automatically.Note: If WEP is enabled, you must provide other WLAN users with the proper WEP key in order forthem to connect to the terminal.You are now ready to Register with the Network.12 Hughes 9201 BGAN Terminal User's Guide 2.2
CONNECTING WITH THE NETWORKEstablishing a connection with the network requires the careful orientation of the BGAN terminaltowards the satellite, a process called pointing. Accurate and precise pointing is important,because a badly-pointed antenna can reduce the data rate achievable over the network.When pointing is complete, you can register the terminal with the BGAN network.CHECKING THE GPS STATUSAfter you have connected your terminal to a computer, you can check the GPS status byopening BGAN LaunchPad. Refer to the BGAN LaunchPad status bar and the GPS indicator lighton your BGAN terminal for the current GPS status. The table below indicates each possible status:LaunchPad Statusbar symbolTerminal GPS indicatorlightFlashing GreenSolid GreenOffFlashing RedSolid RedStatusThe terminal is getting a GPS fix after beingturned on. If you have not changed locationsince last registering, you may be able to reregisterwith your last valid fix. Otherwise waituntil a new fix has been obtained beforeregistering.The terminal has a valid GPS fix. You are readyto point the terminal and register.The terminal has successfully registered.The network will not allow you to register withthe stored GPS fix. You need to get a new GPSfix.The GPS receiver in the terminal is faulty.Contact your Service Provider.Hughes 9201 BGAN Terminal User's Guide 2.2 13
Page 2: Copyright © 2007 Hughes Network Sy
Page 5 and 6: PACEMAKERSThe various brands and mo
Page 7: Size and Weight ...................
Page 11 and 12: INTRODUCTIONABOUT THIS PRODUCTThe H
Page 13 and 14: PACKAGE CONTENTSWhen you unpack the
Page 15 and 16: GETTING STARTEDINTRODUCTION TO GETT
Page 17 and 18: PUT THE BATTERY ON CHARGETo charge
Page 19 and 20: which case the terminal may be able
Page 21: CONNECTING BY ETHERNETTo connect th
Page 25 and 26: 5. After you have positioned the Te
Page 27 and 28: 5. When you have successfully regis
Page 29 and 30: REGISTRATION STATUS AND COVERAGE MA
Page 31 and 32: LAUNCHPAD SOFTWARE INSTALLATIONSUPP
Page 33 and 34: 2. Follow the on-screen instruction
Page 35 and 36: • Installation CompleteHughes 920
Page 37 and 38: ESTABLISHING COMMUNICATIONS BETWEEN
Page 39 and 40: INDICATOR LIGHTS (LEDS)The LEDs ind
Page 41 and 42: These LEDs also indicate the signal
Page 43 and 44: The Extended lithium ion battery pa
Page 45 and 46: ISDN COMPATIBLE DEVICESThe terminal
Page 47 and 48: PERSONALIZATIONAfter the PIN check,
Page 49 and 50: In the second phase, the Upgrader l
Page 51 and 52: hexadecimal format. If you have pro
Page 53 and 54: BGAN SERVICESVOICE TELEPHONY SERVIC
Page 55 and 56: SupplementaryServiceDescriptionStri
Page 57 and 58: DATA SERVICESLaunchPad provides a v
Page 59 and 60: OPENING DATA CONNECTIONSData connec
Page 61 and 62: OPENING A DEDICATED STREAMING CONNE
Page 63 and 64: OPENING A VPNTo open a VPN connecti
Page 65 and 66: 9. Click on Apply to save the displ
Page 67 and 68: MANAGING ISDN CONNECTIONSOPENING AN
Page 69 and 70: If a user has a TE device that can
Page 71 and 72: USIM APN MODE VS. MANUAL APN MODETh
Page 73 and 74:
Hughes 9201 BGAN Terminal User's Gu
Page 75 and 76:
The phonebook is stored on the USIM
Page 77 and 78:
From this window you can:• Create
Page 79 and 80:
DELETING A CONTACTTo delete a conta
Page 81 and 82:
TCP PEP SOFTWARETransmission Contro
Page 83 and 84:
2. Click on OK to restart the termi
Page 85 and 86:
CONFIGURING A CONNECTIONThis sectio
Page 87 and 88:
5. Click on Apply to save the displ
Page 89 and 90:
CONFIGURING ROUTING OPTIONSTo confi
Page 91 and 92:
CONFIGURING SUPPORT DETAILSUsing th
Page 93 and 94:
EXPORTING A USER LOGINIf required,
Page 95 and 96:
CHANGING THE FACILITY PASSWORDYou c
Page 97 and 98:
SOFTWARE VERSIONS AND AVAILABILITYY
Page 99 and 100:
To clear a BGAN log file from your
Page 101 and 102:
2. Select the file to email from th
Page 103 and 104:
POWER-ON SELF-TESTSATELLITE TERMINA
Page 105 and 106:
The following screen appears:Click
Page 107 and 108:
The following functions are also av
Page 109 and 110:
Problem Possible Cause Possible Sol
Page 111 and 112:
TECHNOLOGY OVERVIEWGPSThe Global Po
Page 113 and 114:
WLANWireless Local Area Networking
Page 115 and 116:
DECLARATION OF CONFORMITYHughes Net
Page 117 and 118:
affect the data transmission rates.
show all

Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

Create successful ePaper yourself

Delete template?

Save as template?