Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

More documents

Recommendations

Info

TERMINAL OVERVIEWSIZE AND WEIGHTThe Satellite Terminal is 27.5 cm x 34.5 cm x 5.0 cm. Its weight is 2.8 kg (including the battery).The small size and weight allows you to easily move it from site to site, and it can be connectedat a new site in minutes.TERMINAL INTERFACESINTERFACE OVERVIEW AND DEFAULTSThe Satellite Terminal includes four interfaces that can connect to your computer.• Ethernet• USB• ISDN (for voice and data)• WLAN (IEEE 802.11b)By default the ISDN, USB and Ethernet interfaces are active when the unit is turned on. The802.11b Wireless LAN (WLAN) interface is disabled by factory default, but by using the BGANLaunchPad you can configure the WLAN to be on at startup.When the Terminal is connected to a DC power source, such as mains, the ISDN interfaceremains on at all times. When running from the battery, the ISDN interface will turn off 5 minutesafter pointing is completed if no ISDN device is connected. You can re-enable the ISDNinterface from the BGAN LaunchPad if you subsequently need to connect an ISDN device. Thissaves power and maximizes operating times because the power sourcing circuitry uses powereven if no device is connected. If an ISDN device is connected at power up and thendisconnected before the timer expires, the ISDN interface will power off.The following table summarizes the interface on/off behavior during battery and DC Poweroperation.Interface Battery Operation DC Power OperationUSB On OnEthernet On OnISDNOn.OnAfter 5 minutes if no ISDNdevice detected, turns off.WLANOff(default)OffOffEnabled On On26 Hughes 9201 BGAN Terminal User's Guide 2.2
ESTABLISHING COMMUNICATIONS BETWEEN COMPUTER AND SATELLITE TERMINALETHERNETEthernet communications are established by connecting your computer Ethernet LAN portdirectly to the Satellite Terminal LAN port via the supplied Ethernet cable and monitoring theBGAN LaunchPad for the connection.USBUSB communications are established by connecting your computer USB port directly to theSatellite Terminal LAN port via the supplied USB cable and monitoring the BGAN LaunchPad forthe connection. Please ensure that you have the USB driver installed.ISDNISDN communications are established by connecting your computer ISDN port or ISDN devicedirectly to the Satellite Terminal ISDN port via the supplied ISDN cable (same as the Ethernetcable).With the ISDN interface you can make voice or data calls. Only one terminal at a time maymake a call since only one B channel is supported per Terminal in the BGAN system. However,up to four ISDN phones may be utilized with the one ISDN connection, using a passive ISDNsplitter. Only one of the ISDN devices may make a call at one time..WLANThe WLAN function is used in access point mode. You can use the BGAN LaunchPad toconfigure the following parameters:• Wireless LAN interface on/off. The default is off.• Network (SSID) name. The default is “BGAN” but you can change it.• Channel number. This controls the radio channel number (1-14) used by the access point.Depending on the country only certain subsets of these channels may be used (3 options:France, Spain or Rest of the World). Channel 11 is common to almost all countries, so it isused as the default.• Encryption. 64 or 128 bit WEP encryption can be enabled. Up to 4 WEP keys can be entered,in either Hexadecimal or ASCI format.• Note: Not all Operating Systems will convert ASCI to hexadecimal when setting up a WLANconnection. If you have any problems, please use the hexadecimal WEP key to connectyour computer to the terminal.Up to eleven WLAN users can access the Satellite Terminal simultaneously.Hughes 9201 BGAN Terminal User's Guide 2.2 27
Page 2: Copyright © 2007 Hughes Network Sy
Page 5 and 6: PACEMAKERSThe various brands and mo
Page 7: Size and Weight ...................
Page 11 and 12: INTRODUCTIONABOUT THIS PRODUCTThe H
Page 13 and 14: PACKAGE CONTENTSWhen you unpack the
Page 15 and 16: GETTING STARTEDINTRODUCTION TO GETT
Page 17 and 18: PUT THE BATTERY ON CHARGETo charge
Page 19 and 20: which case the terminal may be able
Page 21 and 22: CONNECTING BY ETHERNETTo connect th
Page 23 and 24: CONNECTING WITH THE NETWORKEstablis
Page 25 and 26: 5. After you have positioned the Te
Page 27 and 28: 5. When you have successfully regis
Page 29 and 30: REGISTRATION STATUS AND COVERAGE MA
Page 31 and 32: LAUNCHPAD SOFTWARE INSTALLATIONSUPP
Page 33 and 34: 2. Follow the on-screen instruction
Page 35: • Installation CompleteHughes 920
Page 39 and 40: INDICATOR LIGHTS (LEDS)The LEDs ind
Page 41 and 42: These LEDs also indicate the signal
Page 43 and 44: The Extended lithium ion battery pa
Page 45 and 46: ISDN COMPATIBLE DEVICESThe terminal
Page 47 and 48: PERSONALIZATIONAfter the PIN check,
Page 49 and 50: In the second phase, the Upgrader l
Page 51 and 52: hexadecimal format. If you have pro
Page 53 and 54: BGAN SERVICESVOICE TELEPHONY SERVIC
Page 55 and 56: SupplementaryServiceDescriptionStri
Page 57 and 58: DATA SERVICESLaunchPad provides a v
Page 59 and 60: OPENING DATA CONNECTIONSData connec
Page 61 and 62: OPENING A DEDICATED STREAMING CONNE
Page 63 and 64: OPENING A VPNTo open a VPN connecti
Page 65 and 66: 9. Click on Apply to save the displ
Page 67 and 68: MANAGING ISDN CONNECTIONSOPENING AN
Page 69 and 70: If a user has a TE device that can
Page 71 and 72: USIM APN MODE VS. MANUAL APN MODETh
Page 73 and 74: Hughes 9201 BGAN Terminal User's Gu
Page 75 and 76: The phonebook is stored on the USIM
Page 77 and 78: From this window you can:• Create
Page 79 and 80: DELETING A CONTACTTo delete a conta
Page 81 and 82: TCP PEP SOFTWARETransmission Contro
Page 83 and 84: 2. Click on OK to restart the termi
Page 85 and 86: CONFIGURING A CONNECTIONThis sectio
Page 87 and 88:
5. Click on Apply to save the displ
Page 89 and 90:
CONFIGURING ROUTING OPTIONSTo confi
Page 91 and 92:
CONFIGURING SUPPORT DETAILSUsing th
Page 93 and 94:
EXPORTING A USER LOGINIf required,
Page 95 and 96:
CHANGING THE FACILITY PASSWORDYou c
Page 97 and 98:
SOFTWARE VERSIONS AND AVAILABILITYY
Page 99 and 100:
To clear a BGAN log file from your
Page 101 and 102:
2. Select the file to email from th
Page 103 and 104:
POWER-ON SELF-TESTSATELLITE TERMINA
Page 105 and 106:
The following screen appears:Click
Page 107 and 108:
The following functions are also av
Page 109 and 110:
Problem Possible Cause Possible Sol
Page 111 and 112:
TECHNOLOGY OVERVIEWGPSThe Global Po
Page 113 and 114:
WLANWireless Local Area Networking
Page 115 and 116:
DECLARATION OF CONFORMITYHughes Net
Page 117 and 118:
affect the data transmission rates.
show all

Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

Create successful ePaper yourself

Delete template?

Save as template?