Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

More documents

Recommendations

Info

USING THE BGAN LAUNCHPAD POINTING WIZARDInmarsat recommends that you use LaunchPad’s Pointing Wizard to point your Terminal to thesatellite. You can also point your Terminal using the Terminal’s LEDs and audio indicator.The BGAN LaunchPad Pointing Wizard steps you through the process of pointing your terminal,and registers with the network. To do this, first start the BGAN LaunchPad on your computer. Thestatus bar displays the message In Pointing Mode.1. Confirm your nearest city in the information box to the left of the map. You can change it byclicking on the map at your current location or click on nearest city and then select from thelist. Your location will be used to determine the recommended antenna angle and compassdirection. Until you successfully register with the BGAN system, your GPS position will not beshown on the map. LaunchPad gives the compass direction in both degrees and direction,the compass shows direction as North, South, East and West, with 10 degree divisions.2. Click on Help me setup BGAN.3. Step through the instructions to correctly position the terminal.4. When you are ready to register with the network, click on Register with Network now. Refer toRegistering with the Network. Note: You can also register with the network by pressing the“Audio” button on the terminal for 3-4 seconds. Once the GPS light goes out, the terminal isregistered with the network and you can start to make ISDN calls without the use ofLaunchPad.16 Hughes 9201 BGAN Terminal User's Guide 2.2
5. When you have successfully registered with the network, your position will be displayed onthe map, but only if allowed by local regulations.USING THE BGAN TERMINAL SIGNAL QUALITY LEDSTo point the antenna using the LEDs:1. Set the angle and position of the BGAN terminal using the compass and the graduatedscale. If you do not know the angle and position to set the terminal to, use the BGANLaunchPad pointing wizard.Note the Pointing indicator LEDs as you point the terminal to obtain the maximum possiblesignal quality.2. The following table shows the colors of the pointing LEDs from the weakest to strongest, asyou point the terminal to the BGAN satellite3. When you have finished pointing the terminal, you are ready to register with the network. Goto the next section Registering with the Network.USING THE AUDIO BUZZERYou can also monitor the signal quality using the audio buzzer. By default the audio buzzer isswitched off. To use the buzzer when the terminal is in pointing mode:1. Press the audio button to turn the buzzer on.2. Monitor the signal quality using the buzzer. The higher the pitch and the shorter the intervalbetween tones, the stronger the signal.Hughes 9201 BGAN Terminal User's Guide 2.2 17
Page 2: Copyright © 2007 Hughes Network Sy
Page 5 and 6: PACEMAKERSThe various brands and mo
Page 7: Size and Weight ...................
Page 11 and 12: INTRODUCTIONABOUT THIS PRODUCTThe H
Page 13 and 14: PACKAGE CONTENTSWhen you unpack the
Page 15 and 16: GETTING STARTEDINTRODUCTION TO GETT
Page 17 and 18: PUT THE BATTERY ON CHARGETo charge
Page 19 and 20: which case the terminal may be able
Page 21 and 22: CONNECTING BY ETHERNETTo connect th
Page 23 and 24: CONNECTING WITH THE NETWORKEstablis
Page 25: 5. After you have positioned the Te
Page 29 and 30: REGISTRATION STATUS AND COVERAGE MA
Page 31 and 32: LAUNCHPAD SOFTWARE INSTALLATIONSUPP
Page 33 and 34: 2. Follow the on-screen instruction
Page 35 and 36: • Installation CompleteHughes 920
Page 37 and 38: ESTABLISHING COMMUNICATIONS BETWEEN
Page 39 and 40: INDICATOR LIGHTS (LEDS)The LEDs ind
Page 41 and 42: These LEDs also indicate the signal
Page 43 and 44: The Extended lithium ion battery pa
Page 45 and 46: ISDN COMPATIBLE DEVICESThe terminal
Page 47 and 48: PERSONALIZATIONAfter the PIN check,
Page 49 and 50: In the second phase, the Upgrader l
Page 51 and 52: hexadecimal format. If you have pro
Page 53 and 54: BGAN SERVICESVOICE TELEPHONY SERVIC
Page 55 and 56: SupplementaryServiceDescriptionStri
Page 57 and 58: DATA SERVICESLaunchPad provides a v
Page 59 and 60: OPENING DATA CONNECTIONSData connec
Page 61 and 62: OPENING A DEDICATED STREAMING CONNE
Page 63 and 64: OPENING A VPNTo open a VPN connecti
Page 65 and 66: 9. Click on Apply to save the displ
Page 67 and 68: MANAGING ISDN CONNECTIONSOPENING AN
Page 69 and 70: If a user has a TE device that can
Page 71 and 72: USIM APN MODE VS. MANUAL APN MODETh
Page 73 and 74: Hughes 9201 BGAN Terminal User's Gu
Page 75 and 76: The phonebook is stored on the USIM
Page 77 and 78:
From this window you can:• Create
Page 79 and 80:
DELETING A CONTACTTo delete a conta
Page 81 and 82:
TCP PEP SOFTWARETransmission Contro
Page 83 and 84:
2. Click on OK to restart the termi
Page 85 and 86:
CONFIGURING A CONNECTIONThis sectio
Page 87 and 88:
5. Click on Apply to save the displ
Page 89 and 90:
CONFIGURING ROUTING OPTIONSTo confi
Page 91 and 92:
CONFIGURING SUPPORT DETAILSUsing th
Page 93 and 94:
EXPORTING A USER LOGINIf required,
Page 95 and 96:
CHANGING THE FACILITY PASSWORDYou c
Page 97 and 98:
SOFTWARE VERSIONS AND AVAILABILITYY
Page 99 and 100:
To clear a BGAN log file from your
Page 101 and 102:
2. Select the file to email from th
Page 103 and 104:
POWER-ON SELF-TESTSATELLITE TERMINA
Page 105 and 106:
The following screen appears:Click
Page 107 and 108:
The following functions are also av
Page 109 and 110:
Problem Possible Cause Possible Sol
Page 111 and 112:
TECHNOLOGY OVERVIEWGPSThe Global Po
Page 113 and 114:
WLANWireless Local Area Networking
Page 115 and 116:
DECLARATION OF CONFORMITYHughes Net
Page 117 and 118:
affect the data transmission rates.
show all

Hughes 9201 BGAN Terminal User's Guide 2.2 - GMPCS Personal ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?