Planning with SIVACON 8 PS - Siemens

Planning with LRC6.2 System componentsIf required, it must be possible to fit the busbar trunking system with an asbestos-freefireproof barrier for wall or ceiling mounting which is compliant with the fire resistance classS60, S90 or S120.The enclosure is made of cast resin and shall be paint-finished in a stone grey similar to RAL7030 (light grey). The cross section of the trunking units must not exceed the dimensionsspecified in the technical data.The individual system components must be connected by screwing on a state-of-the-artbolted joint block.The busbars must be made of copper. The conductor cross sections must not go below thevalues specified in the technical data.The fire load must not exceed the value specified in the technical data.Conformity and test certificatesThe manufacturer of the busbar system must have in place and be able to prove compliancewith a quality management system in accordance with EN/ISO 9001.Proof of compliance with the following requirements must be provided for the entire systemin the form of certificates or declarations of conformity:● Type test acc. to DIN EN 60439-1/VDE 0660-500 and DIN EN 60439-2/VDE 0660-502● Resistance to extreme climates acc. to IEC 60068-2-78 (constant) and IEC 60068-2-30(cyclic)● Fireproof barrier acc. to DIN 4102-9● Maintenance-free● Silicone and halogen-free● Separate bars for PEReliable proof of special additional characteristics (e.g. functional endurance) of systemcomponents must be provided.Planning with SIVACON 8 PSPlanning Manual, 10/2007, A5E01541101-01 209