Planning with SIVACON 8 PS - Siemens

Planning with LRC6.2 System components6.2.7 Distribution board connection for Siemens power distribution boardsFor the LRC system, an LX connection unit in conjunction with an LRC adapter element canbe used to achieve a type-tested link to Siemens power distribution boards.6.2.8 Connection unit for non-Siemens distribution boardsIf you wish to connect the busbar trunking system to a non-Siemens distribution board, youcan establish this connection using an LRC....-T. connection unit for non-Siemensdistribution boards. The connection unit is built into the distribution board and serves as aninterface to the copper connections of the distribution system.VersionsCopper conductors are used for connection units for non-Siemens distribution boards. Therated currents up to a maximum of 6300 A correspond to the data in the Technical datasection. The required conductor cross sections for copper connections are also listed in theTechnical data section.Installing the connection unitThe connections in the distribution board must be copper-plated by the board manufactureror in compliance with that manufacturer's specifications. The board manufacturer mustensure that the required short-circuit rating is achieved and the permissible temperature limitof the non-Siemens connection unit is not exceeded.Figure 6-4Connection unit for non-Siemens distribution boardsLengthX ≤ 0.50 mZ = 0.30 mSystemLRC01 to LRC29The phase clearance of the terminating tags can be varied as required. Dimension Xchanges accordingly.Planning with SIVACON 8 PSPlanning Manual, 10/2007, A5E01541101-01 217