TRITON - Web Security Help, Version 7.7 - Websense

Network ConfigurationUse the Add IP Addresses or Edit IP Addresses page to make changes to any of thefollowing Network Agent lists: Internal Network Definition, Internal Traffic toMonitor, Proxies and Caches, Monitor List, or Monitor List Exceptions.Both IPv4 and IPv6 addresses and ranges are supported.When you add or edit an IP address range, make sure that it does not overlap anyexisting entry (single IP address or range) in the list.When you add or edit a single IP address, make sure that it does not fall into arange that already appears in the list.To add a new IP address or range:1. Select the IP address or IP address range radio button.2. Enter a valid IP address or range.3. Click OK to return to the previous Network Agent Settings page. The new IPaddress or range appears in the appropriate table.To return to the previous page without caching your changes, click Cancel.4. Repeat this process for additional IP addresses, as needed.When you edit an existing IP address or range, the Edit IP Addresses page displays theselected item with the correct radio button already selected. Make any necessarychanges, and then click OK to return to the previous page.When you are finished adding or editing IP addresses, click OK on the NetworkAgent Settings page. Changes are not implemented until you click Save and Deploy.Verifying Network Agent configurationTRITON - Web Security Help | Web Security Solutions | Version 7.7.xAfter configuring Network Agent in TRITON - Web Security, you can use any thirdpartypacket analyzer to ensure that computers on your network are visible toWebsense software.Make sure that the network card that you have configured as the Network Agentmonitoring NIC can see traffic from IP addresses in all network segments that theNetwork Agent instance has been configured to monitor. (This configuration is doneon the Local Settings > NIC Configuration > Monitor List page. See Configuringmonitoring settings for a NIC, page 444.)If packets from some IP addresses are not visible to the monitoring NIC:Review the network configuration and NIC placement requirements (see theDeployment and Installation Center or Network Agent Quick Start)Verify that you have properly configured the monitoring NIC (Configuring NICsettings, page 443).446 Websense Web Security Solutions