SolarEdge

Chapter 6: User Interface
Chapter 6: User Interface
LCD User Buttons
Four buttons are located inside the inverter above the LCD panel and are used for controlling
the LCD menus, as shown below:
Figure 17: LCD Internal menu buttons
Use the four user buttons to control the LCD panel menus:
• Esc: Moves the cursor (>) to the beginning of the currently displayed parameter; goes
to the previous menu, and cancels a value change with a long press (until Aborted is
displayed).
• Up (1) and Down (2): Moves the cursor from one menu option to another, moves
among the characters of a displayed parameter, and toggles between possible
characters when setting a value.
• Enter (3):Selects a menu option and accepts a value change with a long press (until
Applied is displayed).
Use the three rightmost buttons for entering 123 when entering the Setup mode password
12312312.
The LCD screen displays status information of the system and various menus for configuration
options. The LCD panel and buttons are used during the following processes:
• Operational mode: The LCD panel allows checking for proper system operation. Refer
to Status Screens - Operational Mode on page 48 for a description of this option. Use
the LCD light button to toggle through the informative displays.
• Setup mode: Upon installation, the installer may perform basic configuration, as
described in Inverter Configuration – Setup Mode on the facing page.
36
SolarEdge-Installation Guide MAN-01-00057-3.1