SolarEdge

Maintenance
Maintenance
Select Maintenance to set the following options:
D a t e a n d T i m e
R e s e t C o u n t e r s
F a c t o r y R e s e t
S W U p g r a d e S D - C a r d
D i a g n o s t i c s
S t a n d b y M o d e
G r i d P r o t e c t i o n
• Date and Time: Set the internal real-time clock. If connected to the SolarEdge
monitoring portal, the date and time are set automatically and only time zone should
be set.
• Reset Counters: Resets the accumulated energy counters that are sent to the SolarEdge
monitoring portal
• Factory Reset: Performs a general reset to the default device settings.
• SW Upgrade SD-Card: Perform a software upgrade using an SD card.
• Diagnostics: Displays the Isolation Status screen. Refer to
http://www.solaredge.us/files/pdfs/application_note_isolation_fault_
troubleshooting.pdf.
• Standby Mode: Enables/disables Standby Mode - for remote commissioning.
• Grid Protection: Available in specific countries. Enables viewing and setting grid
protection values. Refer to http://www.solaredge.com/files/pdfs/viewing_grid_
protection_values.pdf.
Information
Select Information to display the following options:
V e r s i o n s
E r r o r L o g
W a r n i n g l o g
H a r d w a r e I D s
• Versions: Displays inverter firmware versions:
o
o
o
ID: The inverter ID.
DSP 1/2: The DSP digital control board firmware version
CPU: The communication board firmware version
NOTE
Please have these numbers ready when you contact SolarEdge Support.
46
SolarEdge-Installation Guide MAN-01-00057-3.1