SolarEdge

Communication Ports Status
• IP: The DHCP provided address
• GW: The gateway IP address
• SSID: Service Set Identifier - the name of a wireless local area network (WLAN). All
wireless devices on a WLAN must employ the same SSID in order to communicate with
each other.
• RSSI: The receive signal strength indication of the closest Wi-Fi in the SolarEdge
system. L = low, M = medium, H = high
and - = no signal.
Communication Ports Status
D e v P r o t # #
R S 4 8 5 - 1 < S E > < S > < - - >
Z i g B e e < S E > < M P S > < - - >
• ##: The total number of slaves detected on the specific port
• Dev: The type of device that was configured to a specific port (based on the port’s
functionality), as follows:
o SE: SolarEdge device (default)
o
o
DM: Revenue meter
LGR: Non-SolarEdge logger
• PROT: The protocol type to which the port is set:
o
o
o
Fan Status
For a SolarEdge device:
• S: SolarEdge slave
• M: SolarEdge master
• P2P: ZigBee point-to-point
• MPM: ZigBee multipoint master (for the SolarEdge ZigBee home
gateway)
• MPS: ZigBee multipoint slave (for a ZigBee router module)
For electricity meters, refer to the application note - Connecting an Electricity
Meter to SolarEdge Devices at
http://www.solaredge.com/files/pdfs/connecting-revenue-grade-meter-tosolaredge-devices.pdf.
SS: SunSpec - for a non-SolarEdge logger
This window is applicable to Three Phase Inverters inverters and provides information about
the status of the inverter external and internal fans:
52
SolarEdge-Installation Guide MAN-01-00057-3.1