SolarEdge

Creating a Wireless ZigBee Connection
3. Use the user buttons to configure the connection. To set the inverter designated as
master, select the following in the LCD menus:
• Communication è Server è LAN, ZigBee or Wi-Fi
• RS485-1 Conf. è Device Type è SolarEdge
• RS485-1 Conf. è Protocol è Master
• RS485-1 Conf. è Slave Detect
The system starts automatic detection of the SolarEdge slave inverters connected to
the master inverter. The inverter should report the correct number of slaves. If it does
not, verify the connections and terminations.
4. Verify the connection of the master to the SolarEdge monitoring portal, as described in
Verifying the Connection on the facing page.
Creating a Wireless ZigBee Connection
This communication option enables using a ZigBee connection to connect one or several
devices to the SolarEdge monitoring portal.
The ZigBee device is provided with a user manual, which should be reviewed prior to
connection. It is available on the SolarEdge website at
http://www.solaredge.com/groups/products/communication (under ZigBee).
Creating a Wi-Fi Connection
This communication option enables using a Wi-Fi connection for connecting the device to the
SolarEdge monitoring portal.
The Wi-Fi kit can be purchased separately and assembled during system installation. The Wi-
Fi kit is provided with a user manual, which should be reviewed prior to connection. It is
available on the SolarEdge website at
http://www.solaredge.com/groups/products/communication (under Wi-Fi).
64
SolarEdge-Installation Guide MAN-01-00057-3.1