Basic Characteristics RAPID

[ \V ] (Velocity) Data type: num
This argument is used to specify the velocity of the TCP in mm/s directly in the
instruction. It is then substituted for the corresponding velocity specified in the
speed data.
[ \T ] (Time) Data type: num
This argument is used to specify the total time in seconds during which the robot
moves. It is then substituted for the corresponding speed data.
Zone Data type: zonedata
Zone data for the movement. Zone data describes the size of the generated corner
path.
[ \Z ] (Zone) Data type: num
This argument is used to specify the position accuracy of the robot TCP directly
in the instruction. The length of the corner path is given in mm, which is substituted
for the corresponding zone specified in the zone data.
Tool Data type: tooldata
The tool in use when the robot moves. The tool centre point is the point moved
to the specified destination point.
[ \WObj] (Work Object) Data type: wobjdata
Program execution
The work object (coordinate system) to which the robot position in the instruction
is related.
This argument can be omitted, and if it is, the position is related to the world coordinate
system. If, on the other hand, a stationary TCP or coordinated external
axes are used, this argument must be specified.
The tool centre point is moved to the destination point with interpolation of the axis
angles. This means that each axis is moved with constant axis velocity and that all axes
reach the destination point at the same time, which results in a non-linear path.
Generally speaking, the TCP is moved at the approximate programmed velocity
(regardless of whether or not the external axes are coordinated). The tool is reoriented
and the external axes are moved at the same time as the TCP moves. If the programmed
velocity for reorientation, or for the external axes, cannot be attained, the velocity of
the TCP will be reduced.
A corner path is usually generated when movement is transferred to the next section of
the path. If a stop point is specified in the zone data, program execution only continues
when the robot and external axes have reached the appropriate position.
8-MoveJ-2 RAPID Reference Manual