Basic Characteristics RAPID

StorePath Stores the path when an interrupt occurs
Example
StorePath is used to store the movement path being executed when an error or interrupt
occurs. The error handler or trap routine can then start a new movement and, following
this, restart the movement that was stored earlier.
This instruction can be used to go to a service position or to clean the gun, for example,
when an error occurs.
StorePath;
Program execution
Example
Limitations
The current movement path is stored for later use.
The current movement path of the robot and external axes is saved. After this, another
movement can be started in a trap routine or an error handler. When the reason for the
error or interrupt has been rectified, the saved movement path can be restarted.
TRAP machine_ready;
VAR robtarget p1;
StorePath;
p1 := CRobT();
MoveL p100, v100, fine, tool1;
...
MoveL p1, v100, fine, tool1;
RestoPath;
StartMove;
ENDTRAP
When an interrupt occurs that activates the trap routine machine_ready, the
movement path which the robot is executing at the time is stopped at the end of
the instruction (ToPoint) and stored. After this, the robot remedies the interrupt
by, for example, replacing a part in the machine and the normal movement is
restarted.
Only one movement path can be stored at a time.
RAPID Reference Manual 8-StorePath-1