Pro Tools 101_ An Introduction to Pro Tools 11 ( PDFDrive )

Source: Avid ® .
2. Enter the meter you will use for the session and enter 1|1|000 in the
LOCATION field.
3. Choose a note value that corresponds to the desired click timing.
4. Click OK to insert the new meter event at the beginning of the session,
replacing the default meter.
Setting the Session Tempo
When you open a new session in Pro Tools, the tempo defaults to 120 beats
per minute (BPM). If you intend to record with the click and you are working
with a different tempo, make sure to set the session tempo accordingly. If you
know the tempo you will use for the session, you can insert a tempo event at
the beginning of the session.
Tempo events, which can occur anywhere within a Pro Tools session, are
registered and displayed using the Tempo Ruler.
To set the session tempo, do the following:
1. With the Tempo Ruler displayed and the Tempo Ruler Enable option
selected (see the “Tempo Map Mode” section later in this lesson), click
on the ADD TEMPO CHANGE button.
Figure 6.6 The Add Tempo Change button on the Tempo Ruler
Source: Avid ® .
2. Enter the BPM value you will use for the session and enter 1|1|000 in the
LOCATION field.