Pro Tools 101_ An Introduction to Pro Tools 11 ( PDFDrive )

Source: Avid ®
Adjust the EQ settings to reduce the hum:
1. Solo the DX 03 track by clicking on the S button just above the Volume
Fader in the Mix window.
2. Press the SPACE BAR to initiate playback. With Loop Playback enabled,
the clip will loop until playback is stopped.
3. In the EQ III 1-Band plug-in window, activate a Notch filter in the TYPE
section and drag the gray ball in the graphic display to the left until you
hear the hum reduced (around 60 Hz).
4. Press the SPACE BAR to stop playback.
5. Close the plug-in window and un-solo the track.
6. Press CTRL+= (Windows) or COMMAND+= (Mac) to toggle to the Edit
window and press E on your keyboard to return the session to the
previous view.
Add Reverb
Next, you will need to add some reverb to the FX 08 track to help it fit into
the rest of the mix. This project includes an Auxiliary Input track that has
already been configured with the D-Verb plug-in assigned and the track input
assigned to Bus 1-2 (Reverb).
Assign a reverb send on the FX 08 track: