Pro Tools 101_ An Introduction to Pro Tools 11 ( PDFDrive )

When a smaller The smaller clip is cleared from the track with no
clip is completely warning, although this action can be undone.
covered by a larger
clip
When a smaller
clip is placed
inside a larger one
The smaller clip will trim out the audio it covers, so
that when it is dragged away, a hole (delete) results.
The hole can be repaired using the Heal Separation
command.
To move a clip in Slip mode, do the following:
1. Select the GRABBER tool. The cursor will change into a hand.
2. Click on the clip and drag it to the desired destination. An outline of the
clip will appear as you position it.
3. Release the mouse to position the clip.
Tip: As you drag clips, the Start, End, and Length Selection indicator
boxes dynamically update to show you the result of the movement.
Moving Clips in Grid Mode
When using the Grabber tool in Grid mode, moving and dragging clips is
constrained by the current Grid Value pop-up menu setting.
To move a clip in Grid mode, do the following:
1. Verify that the Grid Time Scale and size have been set as desired. (See
the “Configuring the Grid” section earlier in this lesson.)
2. Select the GRABBER tool. The cursor will change into a hand.
3. Click and drag the clip to the desired destination. An outline of the clip
will appear on the track, snapping to each successive Grid line as you
position the clip.
4. Release the mouse to position the clip.
Moving Clips in Shuffle Mode
In Shuffle mode, you can move clips within a track or onto another track, but
their movement is constrained by other clips. When moved, clips