Pro Tools 101_ An Introduction to Pro Tools 11 ( PDFDrive )

not need to be precise.
To record mute automation:
1. Begin playback, keeping the track muted for Bars 1 and 2.
2. As the playback cursor crosses Bar 3 Beat 1, unmute the Reverb track.
You will hear the reverb effect kick in.
3. At Bar 5 Beat 1, mute the Reverb track again. The reverb effect will be
silenced.
4. At Bar 7 Beat 1, unmute the Reverb track. The reverb effect will be
audible again.
5. Allow playback to continue through the end of the vocals and then press
the SPACE BAR to stop playback. If needed, you can place the track back
into Write mode and try the automation pass again.
6. When finished, set the AUTOMATION MODE selector for the Reverb track
back to Read mode.
Bouncing to Disk
In this part of the exercise, you will clean up your mix by silencing the click
and shortening the performance on the Dirty Beats track. Then you will use
the Bounce to Disk function to create a stereo file from your session mix.
To clean up the mix:
1. In the Transport window, disable the METRONOME button to silence the
click.
2. Make sure you are still in Grid mode and set the Grid to 0|0|240 (1/16
note).
3. Using the SELECTOR tool, place the Edit cursor at 9|1|240 on the Dirty
Beats track.
4. Choose EDIT > TRIM CLIP > END TO INSERTION to trim the end of
the clip to the Edit cursor.