Pro Tools 101_ An Introduction to Pro Tools 11 ( PDFDrive )

automatically snap to each other like magnets. You can shuffle their order, but
you cannot leave space between clips or overlap them.
To move a clip in Shuffle mode, do the following:
1. Select the GRABBER tool. The cursor will change into a hand.
2. Drag a clip to the desired destination. The insertion point will snap
between the start and end points of existing clips on the track as you
position the clip.
3. Release the mouse to position the start of the clip at the insertion point.
Adjacent clips reposition themselves as needed to accommodate the clip
and to close up the space left at its point of origin.
Moving Clips in Spot Mode
Spotting is the process of placing clips at predetermined time locations
within your tracks based on exact Time Scale units, such as Min:Secs,
Bars|Beats, or SMPTE time code.
To move and place a clip in Spot mode, do the following:
1. Select the GRABBER tool. The cursor will change into a hand.
2. Click on the desired clip or drag a clip from the Clip List. The Spot
dialog box will appear.
Figure 8.17 The Spot dialog box