(RPL) Assessment Tool Kit - WestOne

Candidate’s name
Assessor’s name
Supervisor’s name
(if applicable)
MEM50205 Diploma of Engineering Technical (Mechanical)
Section 4 – Practical Tasks and Observation Recording Sheets
Demonstration/Observation Checklist
Skill Set 2 – Engineering drafting and design
Task 4 – Create a drawing to meet specifications
Work activity Create a drawing to meet specifications.
Skill Set 2 –
Unit of competency
Assessment location
MEM30002A Produce basic engineering graphics
Date of demonstration Time
Assessor’s/Task Instructions
The candidate is required to create a drawing to meet the following specification:
1. a replaceable coupling for joining two (2) shafts (transmitting 5 kilowatts @ 1000rpm)
2. reference to catalogues to interpret the sizes and tolerances
3. inclusion of all parts including materials selected
4. completion of the drawing to AS1100 specification
5. give a brief outline of the process followed including preliminary notes, calculations and
sketches.
Resources required for this task
Equipment required includes:
� pens
� pencils
� A4 notepad/graph paper
� calculator
� reference texts as necessary
� rule.
Page 105 of 206 © Department of Education and Training 2009
Version 1, July 2009