(RPL) Assessment Tool Kit - WestOne

MEM50205 Diploma of Engineering – Technical (Mechanical)
Section 4 – Practical Tasks and Observation Recording Sheets
Skill Set 2 – Engineering drafting and design
MEM30001A Use computer-aided drafting systems to produce basic engineering
drawings
© Department of Education and Training 2009 Page 70 of 206
Version 1, July 2009
Task
number
MEM30003A Produce detailed engineering drawings 3*
MEM30004A Use CAD to create and display 3-D models 3
MEM30002A Produce basic engineering graphics 4*
Task 3 – Produce drawing using CAD
The candidate is to select an engineering component from their workplace and produce a
detailed drawing using a CAD drafting system.
Task 4 – Create a drawing to meet specifications
The candidate is to create a drawing to meet the following specification:
1. a replaceable coupling for joining two (2) shafts (transmitting 5 kilowatts @ 1000 rpm)
2. reference to catalogues to interpret the sizes and tolerances
3. inclusion of all parts including materials selected
4. completion of the drawing to AS1100 specifications
5. a brief outline of the process followed including preliminary notes, calculations and
sketches.
Skill Set 3 – Engineering materials
3*
Task
number
MEM30007A Select common engineering materials 5*
MEM23061A Select and test mechanical engineering materials 5*
Task 5 – Conduct test on engineering materials
The candidate is to select from a list of common engineering materials provided and in
negotiation with the Assessor, conduct test to evaluate and report material properties. They are
to record test results by completing test sheets/certificates as appropriate.
Skill Set 4 – Simple electrical circuits
Task
number
MEM30025A Analyse a simple electrical system circuit 6
Task 6 – Analyse a simple electrical circuit and develop a circuit diagram
The candidate is to analyse a simple electrical circuit and develop a circuit diagram as per the
assessment instructions.