(RPL) Assessment Tool Kit - WestOne

MEM50205 Diploma of Engineering – Technical (Mechanical)
Section 3 – Interview Question Bank and Recording Sheets
Interview Question Bank and Recording Sheets
Skill Set 2 – Engineering drafting and design
Assessor’s Instructions
The interview should allow the candidate to confirm their knowledge as identified by their Self-Evaluation against relevant units of competency. The
Assessor may use these questions to guide the interview ensuring that the candidate addresses the key points identified for each question.
These key points exist as a guide only, and the Assessor is encouraged to expand on them where necessary to satisfy depth of underpinning knowledge
and skills.
It is recommended that the interview be conducted in the workplace, allowing the candidate access to documents, equipment etc to support their
statements.
Record of interview
Candidate’s name
Assessor’s name
Interview only �
At an RTO’s premises � Name:
How/where was the interview conducted?
In the workplace � Name:
Page 29 of 206 © Department of Education and Training 2009
Version 1, July 2009