(RPL) Assessment Tool Kit - WestOne

MEM50205 Diploma of Engineering – Technical (Mechanical)
Section 7 – Mapping of Assessment Tools
Skill Set 5 – Engineering calculations
Units of competency
MEM30006A Calculate stresses in simple structures
Units of competency
MEM30005A Calculate force systems within simple beam structures
Element Performance Criteria Interview Topic Practical Tasks Supplementary Evidence
MEM30006A Calculate stresses in simple structures
Topic 7 d) e) Task 7 c) d) e)
1.1 The shear stresses in simple bolted connections
are determined
Element 1 – Determine stresses
in simple structures and
mechanical components
Topic 7 d) e) Task 7 c) d) e)
1.2 The nominal weld size or length of weld required
on simple welded connections is determined to
meet load requirements.
Topic 7 f) Task 7 c) d) e)
1.3 Torque distribution diagrams are drawn and used
to calculate torsional shear stress and angle of
twist on threaded bolts subjected to torques.
Topic 7 h) Task 7 c) d) e)
2.1 Appropriate reference materials are used to verify
that stress loading is acceptable and in
accordance with standard operational procedures.
Element 2 – Verify stress levels
using appropriate reference
material
Topic 7 h) Task 7 c) d) e)
2.2 Verification results are reported according to
standard operational procedures.
Required skills Topic 7 d)–h) Task 7
Required knowledge Topic 7 d)–h) Task 7
Dimensions of competency Topic 7 d)–h) � �
� �
Employability skills Problem solving
Communication
© Department of Education and Training 2008 Page 192 of 206
Version 1, July 2009