Cutler-Hammer - Eaton Canada
Cutler-Hammer - Eaton Canada
Cutler-Hammer - Eaton Canada
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Using the Forward/Reverse Button<br />
SECTION 3<br />
Issuing a Reverse Command From Your Keypad<br />
When the Forward indicator is lit, pressing the F/R<br />
(Forward/Reverse) button sends a Reverse<br />
command to the drive and turns On the Reverse<br />
indicator (the Forward indicator goes out).<br />
The Reverse indicator will flash while the drive is<br />
running in the forward direction and will continue to<br />
flash until the drive reaches zero speed. The<br />
Reverse indicator will be lit steady when the drive<br />
begins running in the reverse direction and will<br />
remain steady as long as both the commanded<br />
direction and drive direction are Reverse.<br />
You can issue a Reverse command at any time if<br />
Reverse direction is enabled and the drive is in<br />
KEYPAD mode. If the drive is running in a forward<br />
direction, it causes the drive to change direction. If<br />
the drive is stopped, the drive turns in a reverse<br />
direction the next time you issue a Start command.<br />
This operation can be disabled via a software<br />
parameter (see Section 4, Using the Parameters,<br />
for more information).<br />
The F/R command should not be used to<br />
permanently reverse motor direction. To change<br />
motor direction, disconnect power and reverse any<br />
two motor leads.<br />
Step 1. With the Forward indicator lit, press the<br />
F/R (Forward/Reverse) button.<br />
Scroll<br />
<strong>Cutler</strong>-<strong>Hammer</strong><br />
SETUP<br />
Change Settings<br />
OPERATE<br />
Keypad<br />
Remote<br />
SELECT<br />
Forward<br />
Reverse<br />
AF93/IS903 Instruction Manual<br />
UP<br />
DOWN<br />
F/R<br />
START<br />
STOP<br />
RUN<br />
FAULT<br />
ETN-25.A<br />
3-9