Cutler-Hammer - Eaton Canada

Changing Parameter Settings
SECTION 3
Step 8. Press the Setup button.
The Change Settings indicator comes on.
Step 9. When the parameter you wish to modify
appears on the LCD and the Change
Settings indicator is lit, you are ready to
change the settings.
Note:Some of the parameters, especially
analog and digital outputs, do not display
analog values on the lower display line
when the Change Settings indicator is lit.
Rather, you will select from a list of
conditions or functions when you press the
Up or Down button. See Section 4, Using
the Parameters, for the type of settings
associated with each parameter.
Press the Up or Down button to change
the setting. Press the Up button
momentarily to increase the value one unit,
or display the next condition or function,
and press the Down button momentarily
to decrease the value one unit or display
the next condition or function.
If you keep either button pressed, the
parameter data shown on the bottom line
of the LCD will vary at an increasing rate
with time. When the data nears the desired
value, release the button. Zero in to the
final value by pressing the appropriate
button momentarily.
AF93/IS903 Instruction Manual
3-14
Scroll
SETUP
Change Settings
OPERATE
Keypad
Remote
SELECT
Scroll
Cutler-Hammer
Cutler-Hammer
SETUP
Change Settings
OPERATE
Keypad
Remote
SELECT
Forward
Reverse
UP
DOWN
Forward
Reverse
UP
DOWN
F/R
START
STOP
F/R
START
STOP
RUN
FAULT
ETN-34.A
RUN
FAULT
ETN-35.A