CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Operating</strong> <strong>manual</strong><br />
The following data must be defined:<br />
The machining point (X, Y), the coordinate of the safety plane (Zs), the coordinate of the part<br />
surface (Z), the total machining depth (P), the drilling peck (I) and the dwell at the bottom (t) and<br />
the withdrawal distance after each penetration (B).<br />
Drilling operation (level 3).<br />
It may be used to set the withdrawal coordinate (Zr) after each penetration.<br />
The following data must be defined:<br />
The machining point (X, Y), the coordinate of the safety plane (Zs), the coordinate of the part<br />
surface (Z), the withdrawal coordinate (Zr), the total machining depth (P), the drilling peck (I) and<br />
the dwell at the bottom (t).<br />
Bore milling operation (level 5).<br />
This cycle may be used to increase the diameter of a hole through a helical movement of the tool.<br />
Besides this, if the tool allows it, it is also possible to mill a hole without having to drill it first.<br />
<br />
<br />
k<br />
The following data must be defined:<br />
The machining point (X, Y), the coordinate of the safety plane (Zs), the coordinate of the part<br />
surface (Z), the hole diameter , the diameter of the pre-drilled hole K, the total machining<br />
depth (P), the helical penetration pitch (B), the direction of the helical drilling path and the milling<br />
at the bottom.<br />
Zs<br />
P<br />
3.<br />
WORKING WITH OPERATIONS OR CYCLES<br />
Drilling and center punching operations<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·115·
Change language