CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2.<br />
OPERATING IN JOG MODE<br />
Tool calibration<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·60·<br />
Type of operation.<br />
<strong>Operating</strong> <strong>manual</strong><br />
The cycle may be used to do a measurement or a calibration. To select the desired operation,<br />
position the cursor on the "Measurement / Calibration" field and press the two-color key. To take a<br />
measurement, define the following data.<br />
Kmax Maximum length wear allowed.<br />
Imax Maximum radius wear allowed.<br />
Stop<br />
Chg<br />
Measuring is only available when purchasing the software <strong>option</strong>: "Tool life monitoring".<br />
Probe position.<br />
Cycle behavior when exceeding the maximum wear allowed. Use the two-color key<br />
to select one of them.<br />
The "Stop" <strong>option</strong> interrupts the execution for the user to select another tool. With the<br />
"Chg" <strong>option</strong>, the cycle replaces the tool with another one of the same family.<br />
In this zone, one must indicate whether the cycle assumes the probe position defined in the machine<br />
parameters or the position defined in this zone. To select one of them, use the cursor to select the<br />
"Machine parameters / Programmable parameters" field and press the two-color key.