CNC 8055 - Operating manual (MC option) - Fagor Automation

5.
SAVING PROGRAMS
CNC 8055
CNC 8055i
·146·
Managing programs using the explorer
·MC· OPTION
SOFT: V01.3X
5.8 Managing programs using the explorer
Operating manual
Windows Explorer may be accessed from the PPROG screen by placing the cursor in the "user
programs" area and pressing [RECALL]. Pressing the [ESC] key returns to the PPROG screen.
Accessing the explorer displays a window divided in two areas (left panel and right panel) as shown
in the next figure:
Once in the explorer, it will be possible to select any program of the Ram memory or hard disk
(KeyCF) to edit it or execute it. When selecting the hard disk (KeyCF), the CNC will select the PRG
folder automatically because it is the only folder where programs may be executed.
When selecting programs of the hard disk (KeyCF), only programs from the PRG folder may be
selected.
When returning from the explorer to the PPROG screen with a different device, the CNC will display
a message warning that the device has been changed and requesting confirmation.
Once out of the explorer, the CNC will show an indicator of the device that has been selected. This
indicator will appear to the left of the selected program.
The subroutines and profiles defined in the profile cycles (the profiles defined in the cycle as well as
the associated profile programs) must be in user RAM memory although the call to the cycle may be
in a program of the hard disk (KeyCF).
Programs contained in USB or in DNC (infinite program) can be neither edited nor executed.
The selected device will be maintained even after turning the CNC off or after a Shift/Reset.