CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Operating</strong> <strong>manual</strong><br />
3.4.2 Defining the grooving data<br />
Type of grooving.<br />
Type of grooving.<br />
To select the type of grooving, place the cursor over this icon and press the two-color key.<br />
Coordinates of the starting point.<br />
The coordinates are defined one by one. After placing the cursor on the coordinates of the axes to<br />
be defined, the value is entered in one of the following ways.<br />
Entering the value <strong>manual</strong>ly. Key in the desired value and press [ENTER].<br />
Assign the current machine position.<br />
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so<br />
the selected data assumes the value shown in the top right window and press [ENTER].<br />
The top right window shows the tool position at all times.<br />
Dimensions of the slot (L, H, E, ).<br />
These data are defined one by one. Place the cursor in the corresponding window, key in the desired<br />
value and press [ENTER].<br />
When programming parameter "E" with a value smaller than the tool radius, the <strong>CNC</strong> executes the<br />
slot milling with an "E" value equal to the tool radius.<br />
Machining conditions in Z (Zs, Z, P, I, Fz).<br />
The machining conditions are defined one by one.<br />
The Zs and Z values are defined as the coordinates of the first and last points.<br />
To define the rest of the values (P, I, Fz), go to the corresponding window, key in the desired value<br />
and press [ENTER].<br />
If the penetration step is programmed with a positive sign (I+), the cycle recalculates the step<br />
so all the penetrations are identical, this being equal to or less than the one programmed. If<br />
programmed with a negative sign (I-), the cycle is machined with the given pass (step) except<br />
the last pass that machines the rest.<br />
Milling pass () and finishing stock (z).<br />
These data are defined one by one. Place the cursor in the corresponding window, key in the desired<br />
value and press [ENTER].<br />
3.<br />
WORKING WITH OPERATIONS OR CYCLES<br />
Surface milling and slot milling operations<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·85·