CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6.<br />
EXECUTION AND SIMULATION<br />
Graphic representation<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·154·<br />
6.5 Graphic representation<br />
<strong>Operating</strong> <strong>manual</strong><br />
The operation <strong>manual</strong>, M model, "Graphics" section of the "Execution / Simulation" chapter<br />
describes how to use the graphics display. However, here is a brief description of the softkeys.<br />
Type of graphic<br />
Display area<br />
With this <strong>option</strong> it is possible to re-define the display area by defining the maximum and minimum<br />
values for each axis.<br />
Use the [][] keys to select the maximum and minimum values. Once all the data has been defined,<br />
press [ENTER].<br />
When selecting a new display area, the <strong>CNC</strong> clears the screen and shows the axes or the part<br />
unmachined.<br />
Zoom<br />
When pressing the [GRAPHICS] key, the <strong>CNC</strong> shows the graphics screen of the M model.<br />
To quit the graphics mode, press either [GRAPHICS] or [ESC].<br />
During simulation, the top center window shows the number of the program and the<br />
number of the cycle being executed. However, when detecting an RPT or GOTO<br />
instruction, the cycle number will disappear.<br />
3D It draws the part in three dimensions.<br />
XY, XZ, YZ They draw the part in the selected plane.<br />
COMBINED<br />
VIEW<br />
It divides the screen in four quadrants and draws the graph corresponding to each<br />
plane XY, XZ, YZ and the three-dimensional graph.<br />
TOP VIEW It draws a top view (XY plane) with different shades of gray that indicate the depth<br />
of the part.<br />
It also displays the XZ and YZ sections for the areas shown by the indicators of<br />
the top view (XY plane).<br />
SOLID It shows a three-dimensional block that will be “machined” as the part-program<br />
is being run.<br />
The display area cannot be changed while executing or simulating the part. If it is,<br />
interrupt the execution or simulation by pressing the [STOP] key.<br />
With this <strong>option</strong>, it is possible to enlarge or reduce the graphics display area.<br />
It shows a window superimposed on the current graphics and another one over the drawing at the<br />
lower right-hand side of the screen. These new windows indicate the new display area being<br />
selected.<br />
Use the [][][][] keys to move the window around, the softkeys "ZOOM+" "ZOOM-" to enlarge<br />
or shrink its size and press [ENTER] for those new values to be assumed.
Change language