CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Operating</strong> <strong>manual</strong><br />
4.2.7 Plane change<br />
An icon may be used to select the plane (G16, G17, G18 ó G19)<br />
where the canned cycle will be executed. This way, the cycles may<br />
be executed in any of the three planes.<br />
When selecting G17, G18 or G19, the three boxes are automatically<br />
filled in with the names of the corresponding axes. Also, the main<br />
view highlights the selected plane.<br />
When selecting G16, the user can write the names of the axes in<br />
the boxes as he wishes. In this case, the main drawing does not<br />
highlight any plane.<br />
If there are only XYZ axes, the selection icon does not show the<br />
<strong>option</strong> for free configuration (G16).<br />
After programming a block with a plane change, all the milling cycles<br />
may be executed in the new plane.<br />
When turning the <strong>CNC</strong> off and back on, it loses the plane it was<br />
working with and the work plane is the one indicated by machine<br />
parameter IPLANE (XY or ZX).<br />
Icon that serves to indicate the plane active in the cycle when the selected plane does<br />
not correspond with the plane indicated by general machine parameter IPLANE<br />
(P11). This icon will only be shown before pressing [START], after pressing [ESC].<br />
4.<br />
OPERATING IN ISO MODE<br />
Programming assistance<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·131·
Change language