CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6.<br />
EXECUTION AND SIMULATION<br />
Execution mode<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·152·<br />
6.4 Execution mode<br />
<strong>Operating</strong> <strong>manual</strong><br />
When pressing [START] to execute an operation or part-program, the <strong>CNC</strong> shows the<br />
standard screen of the <strong>MC</strong> mode.<br />
When pressing the two-color key, the <strong>CNC</strong> shows the special screen of the <strong>MC</strong> mode.<br />
During execution, both screens show (in the top center window) the number of the program and the<br />
number of the cycle being executed. However, when detecting an RPT or GOTO instruction, the<br />
cycle number will disappear.<br />
Once the operation or part has been selected, it may be executed as often as desired;<br />
to do that, once the execution has finished, pressed the [START] again.<br />
To interrupt the execution, press [STOP]. Once the execution has been interrupted, a tool<br />
change may be done. See "6.4.1 Tool inspection" on page 153.<br />
While executing an operation or a part, the [GRAPHICS] key may be pressed to access<br />
the graphics display mode.