CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
CNC 8055 - Operating manual (MC option) - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Operating</strong> <strong>manual</strong><br />
6.2 Simulating or executing a part-program<br />
Proceed as follows to simulate or execute a part-program:<br />
1. Press [P.PROG] to access the list of part-programs stored.<br />
2. Select on the left column the program to be simulated or executed.<br />
Press [GRAPHICS] to simulate the part-program and [START] to execute it. When executing a<br />
program, the <strong>CNC</strong> executes the initial subroutine 9998 and the final subroutine 9999.<br />
If an error occurs in a cycle during simulation or execution, when accessing the list of programs<br />
again, the cursor will be placed on the cycle that came up with the error. When program 999998<br />
is displayed on the screen or the error is not an execution error, the cursor will go to the beginning<br />
or to the end of the program depending on its length.<br />
6.<br />
EXECUTION AND SIMULATION<br />
Simulating or executing a part-program<br />
<strong>CNC</strong> <strong>8055</strong><br />
<strong>CNC</strong> <strong>8055</strong>i<br />
·<strong>MC</strong>· OPTION<br />
SOFT: V01.3X<br />
·149·