CNC 8055 - Operating manual (MC option) - Fagor Automation

Operating manual
5.7.4 Modify an existing operation
To modify an operation, proceed as follows:
1. Select, with the pointer, the block or cycle to be modified from the right column.
2. Press the [RECALL] key.
The CNC will show the editing page for that operation.
3. Modify all the desired data.
To save the modified operation, proceed as follows:
1. Press [P.PROG] to access the list of part-programs stored.
The CNC shows the pointer on the same operation. To select another position, use the [][]
keys; the new operation will be inserted after the selected one.
2. Press the [ENTER] key.
To place the modified operation in its previous location, the CNC will show a message asking to either
replace the previous operation or keep it inserting the new one after it.
The following example modifies the "rectangular pocket" operation.
i
Current program Option "Replace" Option "Insert"
1.- Rectangular pocket 1.- Rectangular pocket 1.- Rectangular pocket
2.- Circular pocket 2.- Circular pocket 2.- Rectangular pocket
3.- Circular pocket
It is possible to select an existing operation, modify it and then insert it in another position and even
in another part-program.
5.
SAVING PROGRAMS
Modify a part-program
CNC 8055
CNC 8055i
·MC· OPTION
SOFT: V01.3X
·145·