CNC 8055 - Operating manual (MC option) - Fagor Automation

2.
OPERATING IN JOG MODE
Tool calibration
CNC 8055
CNC 8055i
·MC· OPTION
SOFT: V01.3X
·54·
2.7 Tool calibration
Operating manual
This mode may be used to define the tools and calibrate them. The tools may be
calibrated with or without using a probe.
This mode is also available while executing a program and during tool inspection.
The calibration mode can have three editing levels. The second and third levels will only be available
when using a table-top probe installed on the machine.
Each level has its own screen and the main window of the cycle indicates, with tabs, the
available levels and which one is selected. To change levels, use the [LEVEL CYCLE]
key or the [page up] and [page down] keys to scroll up and down through the various
levels.
What can be done in tool calibration mode
The data that may be modified from the calibration cycles depend on when this mode is accessed.
The following limitations must be borne in mind when accessing the tool calibration mode with a
program in execution or from tool inspection.
Without a program in execution nor in tool inspection.
When editing the active tool, it is possible:
Modify all the data.
Change the active tool (T ?? + [START]).
When NOT editing the active tool, it is possible:
Modify all the data except the part dimensions.
Change the active tool (T ?? + [START]).
Program in execution or interrupted.
When editing the active tool, it is possible:
To modify the I and K data.
Select another tool (T?? + [RECALL]) and modify the I and K data.
When NOT editing the active tool, it is possible:
To modify the I, K and D data.
Select another tool (T?? + [RECALL]) and modify the I, K and D data.
Program in tool inspection.
When editing the active tool, it is possible:
To modify the I and K data.
Select another tool (T?? + [RECALL]) and modify the I and K data.
Change the active tool (T ?? + [START]).
When NOT editing the active tool, it is possible:
To modify the I, K and D data.
Select another tool (T?? + [RECALL]) and modify the I, K and D data.
Change the active tool (T ?? + [START]).