1928 Cadillac - GM Heritage Center

."">
Use upper hole for 14-inch front brakes
If division bar has only one hole
drill new hole 3/8 inch up
If pedal has only one
hole, drill new hole
7/16 inch nearer shaft
t=mml
Jse lower hole for 16-inch front brakes
'Division bar
7 Make sure pedal rod is connected
to proper hole in division bar
Gauge 109420
has three holes,
connect pedal rod to middle hole in pedal.
Adjust yoke so lever clears screw in bracket
To change position of
lever, loosen clamp screw
and slide lever off splines
CO
to
>
w
Check position of cable levers.
Preferably use gauge.
(Omit this step on all cars
with 14-inch front brake
drum* and on cars with
16-inch drums which have
levern welded on shaft)
•Cable lever
l/2 inch in applied position
(first type with camoperated
brakes)
1-1/4 inches in released position
(second type with toggleoperated
brakes)
VO