ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Troubleshooting the Rapid Sample Introduction System
ASXPRESS system. To do so, verify proper operation of all manual functions by
completing the following steps:
1 Operate manual features of the Xpress Config Tool software.
With the ASXPRESS system connected to the autosampler/ICP/ICP-MS systems,
the autosampler “queried” (Chapters 3 and 4), and the manual functions
showing in the Xpress Config software window:
o
o
o
o
o
o
o
Click the “Manual Cycle” button. The ASXPRESS system should run through a
complete cycle (“Load” and “Inject”), operating the autosampler peristaltic
pump and the ASXPRESS components (6-Port Valve and Vacuum Pump).
Click the “Load” button. The ASXPRESS system should move the 6-Port Valve
to the “Load” position (no other apparatus operates).
Click the “Inject” button. The ASXPRESS system should move the 6-Port
Valve to the “Inject” position (no other apparatus operates).
Click the “On” (autosampler pump control) button. The autosampler
peristaltic rinse pump should turn on (no other apparatus operates).
Click the “Off” (autosampler pump control) button. The autosampler
peristaltic rinse pump should turn off (no other apparatus operates).
Click the “On” (ASXPRESS vacuum pump control) button. The ASXPRESS
vacuum pump should turn on (no other apparatus operates).
Click the “On” (ASXPRESS vacuum pump control) button. The ASXPRESS
vacuum pump should turn on (no other apparatus operates).
Figure 1-54
functions
Xpress Config Tool—Expanded to access manual
107