ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
Figure 1-55
“Ready to Install the Program” window
5 The “InstallShield Wizard Completed” window appears (Figure 3-
56). Select the “Launch the program” box and then click the
“Finish” button to complete the installation and launch the
program.
Figure 1-56
“InstallShield Wizard Completed” window
6 The Xpress Config Tool software loads and the main window
appears. (Figure 3-57). The parameter labels, fields and select
buttons will be grayed-out as shown until after the
ASXPRESS/autosampler system is “queried”. Figures 3-58 and 3-59
show the Xpress Config Tool window appearance after querying.
66