ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
3.4.2.5 Verification of Firmware Upgrade
1 Start HyperTerminal. (For instructions on using HyperTerminal, refer
to the Guide to Operating a CETAC Autosampler using
HyperTerminal).
2 In HyperTerminal type VERSS. The system should respond with the
new firmware version.
Note it here:________________________
Note:
For additional instructions on using HyperTerminal, refer to the Guide to
Operating a CETAC Autosampler using HyperTerminal located at the
end of this manual. If your computer does not have HyperTerminal
configured already, please refer to this section now.
80