ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
7. Remove the four stand-offs with the 1/4” nut driver
(Figure 1-33). Set these aside for re-assembly.
Figure 1-33 Removing the four stand-offs (ASX-260).
8. Remove the 6 Phillips head screws holding the board in place (Figure
1-34). Unclasp the blue ribbon cable from the bottom clamp.
Figure 1-34 Removing the six screws holding the board in place (ASX-
260).
43