ASXpress Operator's Manual - CETAC Technologies

More documents

Recommendations

Info

ASXpress Rapid Sample Introduction System Operator’s Manual Chapter 3: Installing the Rapid Sample Introduction System 9. The inner shield can be removed by lifting it up while pulling forward (Figure 1-18/Figure 1-19). Figure 1-18 Removal of inner shield (ASX-520). Figure 1-19 Removal of inner shield (ASX-260). 30
ASXpress Rapid Sample Introduction System Operator’s Manual Chapter 3: Installing the Rapid Sample Introduction System To complete I/O board/rabbit module installation for CETAC ASX-520/ ASX-520HS/EXR-8 autosamplers, continue on the next page (32). To complete I/O board/rabbit module installation for the CETAC ASX-260 autosampler, continue on page 38. 31
Page 1 and 2: CETAC ASXPRESS Rapid Sample Introdu
Page 3 and 4: Contents
Page 5 and 6: ASXpress Rapid Sample Introduction
Page 7 and 8: 1 Introduction
Page 15 and 16: 2 Preparing for Installation
Page 19 and 20: 3 Installing the Rapid Sample Intro
Page 29: ASXpress Rapid Sample Introduction
Page 81 and 82:
4 Verifying Installation/ Function
Page 83 and 84:
ASXpress Rapid Sample Introduction
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
5 Using the Rapid Sample Introducti
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
6 Maintaining the Rapid Sample Intr
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
7 Troubleshooting the Rapid Sample
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
8 Glossary
Page 115 and 116:
9 Guide to Operating a CETAC Autosa
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Index
Page 136:
Manual Part Number 480166 Rev 4 Pri
show all

ASXpress Operator's Manual - CETAC Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?