ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
of tubing may be cut to accommodate your specific
position/arrangement.
5. Gently push the Standard Bowl Rinse Station into place onto the rinse
station holder block (mounted on the autosampler front cover) as
shown in place in Figure 1-45.
6. Replace the peristaltic pump input rinse tubing (suction tubing
connecting the input of the peristaltic pump to a rinse solution supply
container) with a single length of tubing, found in the completion kit, as
shown in Figure 1-46 and Figure 1-47. Leave one peristaltic pump
suction channel input open to the atmosphere to allow air to be drawn
in through one channel, while rinse solution is drawn in through the
other channel (Figure 1-47).
55