ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 10: Safety and Regulatory Information
10 Safety and Regulatory Information
Review this product and related documentation to familiarize with safety
markings and instructions before you operate the instrument.
10.1 Characteristics
10.1.1 Environmental Characteristics
Operating Temperature +13° C to +30° C (+55° F to +85° F)
Non-Operating Temperature +0° C to +55° C (+32° to +131° F)
Operating Altitude
Relative Humidity
Up to 2,000 m (6,562 ft)
0% to 60% non-condensing
Pollution Degree Pollution Degree 2
Table 9-2: Environmental Characteristics
For indoor use only.
Normally no pollution or only dry, nonconductive
pollution occurs. The
pollution has no influence. Occasionally,
however, a temporary conductivity
caused by condensation may be
expected.
Avoid sudden, extreme temperature changes which could cause condensation
on circuit boards in the product.
See page 10 for information on chemical compatibility.
10.1.2 Electrical Characteristics
10.1.2.1 Power requirements
Electronics Module
Input:
Power is provided by the CETAC autosampler through the
power/signal cable which is attached to the electronics
module.
DC Voltage and Current
24 V
2.5 A
Installation Category: CAT I (Mains isolated)
Output:
Connector for the valve/pump module.
Valve/Pump Module
Input:
Use only with the provided electronics module.
Installation Category: CAT I (Mains isolated)
Table 9-3: Power Requirements
126