ASXpress Operator's Manual - CETAC Technologies

More documents

Recommendations

Info

ASXpress Rapid Sample Introduction System Operator’s Manual Chapter 3: Installing the Rapid Sample Introduction System 3.1.7 Install the 1.0mm ID Sample Probe on the Autosampler A 1.0mm ID sample probe (Figure 1-48) is provided for use with the CETAC autosampler for proper operation with the ASXPRESS system. Follow the autosampler Operator Manual Instructions to replace the probe with the 1.0mm sample probe, which is attached to the ASXPRESS 6-Port Valve at Port #2. Note: The 1.0mm I.D. sample probe must be installed on the autosampler or the ASXPRESS Rapid Sample Introduction System will not perform properly. It is identified by double blue bands (Figure 1-48) installed on the probe tubing. Figure 1-48 Double Blue Bands Identify the 1.0mm I.D. Sample Probe (carbon fiber probe shown is standard equipment) 56
ASXpress Rapid Sample Introduction System Operator’s Manual Chapter 3: Installing the Rapid Sample Introduction System 3.2 Connect the ASXPRESS system Once the autosampler is prepared for use, the ASXPRESS system should be connected to the host instrument and autosampler, and the autosampler should be connected to the host instrument’s computer. 3.2.1 Connect the ASXPRESS Plumbing All tubing (except sample loop and probe) is pre-connected to the ASXPRESS valve/pump module to allow convenient inter-connection to the autosampler and to the nebulizer per Figure 1-49. The 6-Port valve ports are numbered, color coded, and labeled with a descriptive definition providing clear identification of port functionality. The only connection required at the ASXPRESS 6-Port Valve is the customer-selected sample loop. All other ASXPRESS plumbing is prepared to be connected to the autosampler and ICP/ICP-MS as received in the shipping packaging. Note: All fitting connections on the 6-Port Valve are to be finger tightened only to prevent damage to the valve and tubing. Do not overtighten. 57
Page 1 and 2:
CETAC ASXPRESS Rapid Sample Introdu
Page 3 and 4:
Contents
Page 5 and 6: ASXpress Rapid Sample Introduction
Page 7 and 8: 1 Introduction
Page 15 and 16: 2 Preparing for Installation
Page 19 and 20: 3 Installing the Rapid Sample Intro
Page 55: ASXpress Rapid Sample Introduction
Page 81 and 82: 4 Verifying Installation/ Function
Page 89 and 90: 5 Using the Rapid Sample Introducti
Page 95 and 96: 6 Maintaining the Rapid Sample Intr
Page 103 and 104: 7 Troubleshooting the Rapid Sample
Page 107 and 108:
ASXpress Rapid Sample Introduction
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
8 Glossary
Page 115 and 116:
9 Guide to Operating a CETAC Autosa
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Index
Page 136:
Manual Part Number 480166 Rev 4 Pri
show all

ASXpress Operator's Manual - CETAC Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?