ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
Figure 1-66
“Choose Flash Image” Window.
4 Select the firmware file by filling in the field by selecting the
“browse” button to the right of the field (denoted by […]) (Figure 3-
66), and then selecting the correct file from the CD as depicted in
Figure 3-67 or Figure 3-68. The correlating file name for the field is:
5 For ASX-520, ASX-260 Autosampler
File Location/Name: (drive letter where CD is loaded):\ASX Firmware for
ASXpress\ASXpress_1_19.bin
6 For ASX-520HS (High Speed) Autosampler
File Location/Name: (drive letter where CD is loaded):\ASX Firmware for
ASXpress\High Speed Autosampler Firmware\ASXpress_HS_1_19.bin
Note:
The .bin file name shown in Figure 3-63 (i.e. ASXpress_1_19 or
ASXpress_HS_1_19) will vary depending on which era ASXPRESS FW is
being loaded. CETAC Technologies makes every effort to update the
firmware as needed to ensure that the most beneficial functionality is
provided to the customer.
As of December 2009, the most current firmware version file name is
“ASXpress_1_19” for standard speed autosamplers or
“ASXpress_HS_1_19” for High Speed autosamplers.
Note:
Ensure that the correct firmware file (applying to your specific
autosampler) is selected as illustrated in Figure 3-64 and Figure 3-65, to
ensure correct interface/operation of the ASXPRESS system and
autosampler.
77